eXtreamCS.com

// BlanK Clan HLTV pwd by Love is a feeling configuration file

// BlanK Clan HLTV pwd by Love is a feeling runs this file on start up
// This file should only be edited if you want to broadcast a game

// set BlanK Clan HLTV pwd by Love is a feeling name as shown in score board
name "BlanK Clan HLTV pwd by Love is a feeling

// set BlanK Clan HLTV pwd by Love is a feeling name, how it should appear in game server browsers
// hostname "BlanK Clan HLTV pwd by Love is a feeling"

// set offline info text clients will see as reject reason if HLTV isn't broadcasting yet
offlinetext "Ne cerem scuze pentru aceasta problema. Va rugam, reveniti."

// delays broadcasting for 30 seconds
delay 30.0

// allow 3.5 KByte/sec as client rate. This is good a value
// for internet broadcasts. On LAN you may set this value to 10000
maxrate 3500

// log BlanK Clan HLTV pwd by Love is a feeling console in proxy.log
// logfile 1

// local chatting for HLTV spectators enabled
chatmode 1

// if game server is password protected, enable this line
// serverpassword "mypassword"

// proxy's adim password for rcon, commentator etc.
// adminpassword "mypassword"

// show message for 5 seconds each 60 seconds in center of X axis (-1) and
// above help text bar (0.85). Color given as hexadecimal RGBA .
loopcmd 1 60 localmsg "Urmariti BlanK Clan HLTV pwd by Love is a feeling" 5 -1 0.85 FFA000FF

// hltv.tga will be shown instead of the default HLTV logo in spectator GUI
// bannerfile "hltv.tga"

// these commands will be executed on connecting spectator client and may be used
// to adjust settings for HLTV (for example voice parameters)
signoncommands "voice_scale 2; voice_overdrive 16; volume 0.5; echo Voice adjusted for HLTV"


echo hltv.cfg loaded.

.TheGame. wrote:

Code: Select all

// if game server is password protected, enable this line
// serverpassword "mypassword"

// proxy's adim password for rcon, commentator etc.
// adminpassword "mypassword"

Serverul are parola ? Daca da, completeaza in cfg.

Iar in Cfg-ul cs-ului pune linia:

Code: Select all

sv_proxies 1

1 = cate HLTV-uri accepta serverul tau. Banuiesc ca era setat pe 0 :)